How To Add Additional Vtech Cordless Phones

How to Annals a VTech VSP601 Cordless Handset to the VTech VSP600 Base Station

The steps below detail instructions for registering/deregistering for the pictured cordless handset.For instructions to register a cordless deskset, click here.

VTech VSP601 Cordless Handset

Registering the Handset to the Base Station

1. Make sure the handset has a charged battery earlier proceeding. Also, make certain the base station is connected to power.
2. Printing MENU on the handset. The Main Carte appears.
3. Press the downwards arrow to gyre to User settings, and press SELECT.
4. With Handset highlighted, printing SELECT. The handset screen displays instructions. Press NEXT to continue reading the instructions.
5. On the base station, press the HANDSET LOCATOR button for at least iv seconds, and and so release the button. Both LEDs on the base station brainstorm to wink.
6. Press the # key on the handset to begin registration. The process takes up to 10 seconds to complete.
7. When the handset registers, it beeps and the screen displays HANDSET followed by the handset'south number.

   NOTE: If the handset fails to annals, identify information technology in the charger again for a few seconds, remove it, and repeat the registration process.

Deregistering the Handset from the Base Station

1. Press MENU on the handset. The Principal Menu appears.
2. Press the downward arrow to scroll to User settings, and press SELECT. (If you do not see User settings, click here.)
3. Press the down arrow to ringlet to Registration, and press SELECT.
4. Press the down arrow to highlight Deregistration and press SELECT. The handset screen displays a list of registered handsets.
5. Highlight the name of the handset you want to deregister, and then press SELECT.
6. On the base station, press the HANDSET LOCATOR button for at least four seconds, and then release the push button. Both LEDs on the base of operations station brainstorm to flash.
7. On the handset, enter the Arrangement PIN (1597 by default), and then printing SELECT to begin deregistration. Deregistration takes up to x seconds to complete. When the handset deregisters, it beeps and the screen displays Unregistered.

   Annotation: The handset enters an free energy-saving charging mode after being deregistered. All cordless telephone functions except handset-battery charging are disabled. The energy-saving charging mode is deactivated after the handset registers to a base station.

Was this article helpful?

How To Add Additional Vtech Cordless Phones,

Source: https://www.nextiva.com/support/articles/how-to-register-a-handset-to-your-vtech-vsp600-phone.html

Posted by: malonelencente.blogspot.com

Share this post